Economic beacons - diameter 50mm EMAS (IP54)
This branch includes compact pole lights and parts for their assembly. In the catalog, you will find optical modules IKM5, a base with a plug IKM5G, and assemblies IK5 and TE-IK5. When ordering, first decide whether you are equipping a new workplace or repairing an already mounted pole. The same appearance does not necessarily mean the same range of delivery.
Overview of the IK series from EMAS distinguishes the number of floors, voltage and mounting construction. A specific combination is always determined by the full order code.
Start with the location on the machine
Diameter 50 mm helps in the floor plan design, but does not include the entire space needed for installation. Draw the connector, height of the column, cable outlet and path of opening doors in the drawing. Particularly verify that the upper floor will not be out of the cover edge and that during service, the end can be removed without disassembling surrounding elements.
Select the mounting surface according to stiffness and access from the other side. A long leg on thin sheet metal may impair the readability of the light during machine movement. Before drilling, use the dimensional drawing of precise stops; the diameter of the optical part does not determine the spacing of the mounting holes. Route the cable away from hinges, sharp edges, and areas of regular opening.
Finished assembly, or your own parts list?
Select for a known number of states Assembled signal lights. For the repair of one floor or the assembly of a specific combination, use Individual modules and accessories. For individual components, note especially the optical module, light source, connection base, termination, and mounting. For a finished product, verify which of these parts it includes.
Split the selection into three decisions: how many separate pieces of information you need to display, whether they should light continuously or intermittently, and whether you require sound. Do not confuse a change in the colour module with a change in the electrical function. In the service list, write down complete codes including prefixes and suffixes, so that the next replacement is based on the same construction.
Model example: inspection point on the packaging line
Consider the workstation where the operator stands in front of the table and adds material from the side. The designer marks both positions and checks the view of the intended column with a closed cover. If the lower floor is not visible from the side, adjust the position before ordering the holder. Subsequently, assign individual states their own separate commands and record their meaning in the handover protocol. This is a design example, not a documented installation.
Frequently asked questions
Does the category name IP54 guarantee for every combination?
No. Check the protection of the exact product and its mounting conditions. Pay special attention to additional parts and cable input. For another requirement, compare also the branch Economic beacons - diameter 50mm EMAS (IP65).
Can access to the machine be allowed according to the lighting?
This beacon is used for operational information, it is not a safety device.
What to prepare for replacing an unmarked column?
Document the label, wiring, stop, and individual parts. A single photograph of the colour or the dimension 50 mm is not sufficient to confirm electrical and mechanical compatibility.