Beacon - 70mm APT diameter (IP65)
The signalling column helps the operator recognize the machine's status and from the street. When designing, it decides which events should be visible simultaneously, where the person is watching, and how to react. Simply adding another color does not resolve unclear signalling: assign a unique meaning to each lighting level and determine the priority of simultaneous announcements.
The APT TL-70 selection includes Individual modules and accessories for building or repairing columns and Compound beacons with a defined configuration. Represented are permanently glowing and blinking variants and implementations with acoustic signalling.
How does modular signalling work
The lighting level converts an electrical command into an optical state; several levels allow separating different information spatially. Blinking implementations also change the light over time. In the project, distinguish the event that the control system evaluates and how to display it. Confirmation of an alert does not necessarily mean removing the cause. Audio can be muted separately if the selected assembly allows it.
According to the APT manufacturer for the TL-70 series the coverage is IP65 and allows a maximum of five optical modules, or four optical modules and one acoustic module.
Selection starts with machine
- Write down the states that the operator must distinguish. For each, determine the reaction, priority and condition of the shutdown.
- Select the number of floors and the light function. A permanent light may be suitable for continued information; for the change warning, assess the flashing.
- Check the view at the closed door of the machine, from the site of the material refilling and during the normal lighting of the hall.
- Compare the order code, voltage and connection of each part. The diameter itself does not show a match of electrical contacts, locks or seals.
When repairing, remove the labels and the position of the original parts. Do not judge compatibility by the color of the coating or similar trade designation. Verify the mounting dimensions on the specific component drawing; the nominal diameter of the series is not automatically the maximum outer dimension of the entire assembly.
Covering and installation conditions
IP65 is not an automatic confirmation of suitability for every outdoor installation, chemical abrasion, or pressure washing. Also consider temperature, solar radiation, vibration, and cleaning method. The tightening function depends on the correct assembly and cable input. Do not insert improvised bases between the parts that would change the fit; the cable should not transfer tension to the bolts. First resolve loose or burnt parts as a mounting issue.
Model example: space above the protective cover
Consider only the draft model: the mounting surface is 1.40 m above the floor and the selected assembly with the holder reaches a height of 0.35 m. The upper edge will be 1.40 + 0.35 = 1.75 m. Above the cover, the high 1.65 m leaves only 0.10 m. This result does not prove visibility of the lower floors; they may remain covered. Therefore, check the view from each floor at the workplace. The dimensions are chosen for example, not for the drawing of a specific product.
Frequently asked questions
Can parts of another manufacturer of the same diameter be used?
The interchangeability shall be demonstrated for a specific connection. Compare attachment, contact line and sealing area; the same average is not enough.
Does the light beacon confirm safe access to the machine?
Do not judge normal operating signalling as permission to enter. The conditions for safe access are determined by the solution of the specific machine. For orientation in other constructions, the parent category serves. Signalling beacons.