Free-standing control cabinet enclosures
The range includes EAE ED160x60x60 and ES200x60x40. TECHNOLINE states outer dimensions of 1600 × 600 × 600 mm and 2000 × 600 × 400 mm in the order height, width, depth. The taller enclosure therefore need not be deeper. The selection starts with the floor plan of the equipment, the cable routes and the available space for servicing.
What modular design means
The current series EAE D and EAE S are described by the manufacturer as modular enclosures for indoor installation with the option of side-by-side joining. Accessories and joining conditions must be confirmed for the specific order code.
Modularity makes changes to the mechanical layout easier, but does not mean that parts can be combined arbitrarily. When requesting a quote, compile a list of the required parts: frame, doors, rear and side panels, mounting plate, base and plinth. Check the assembly drawing alongside the list. The term “complete” may describe the mechanical enclosure; it does not by itself confirm fitting with devices, wiring or verification of the electrical control cabinet.
Plan the space in three directions
On the mounting surface, mark the devices, cable trunking and terminal rows. In depth, add connectors, supply cables and door equipment. In height, leave space for the cable to get from the entry to the terminal. Assign each reserve to a specific purpose: wiring, device replacement or future expansion. A mere percentage of free area does not guarantee that space will remain exactly where it is needed.
Before ordering, walk through the transport route including doors and corridor corners. The operating location must allow the doors to be opened and the largest replaceable part to be handled. Verify the flatness of the floor, load capacity, anchoring method and cable routing under the enclosure. The designation “free-standing” by itself does not mean that the fitted enclosure can be used safely without fixing.
Author's model example: width of the mounting area
Consider our own design with a usable width of 480 mm and two side trunkings 60 mm wide. What remains is 480 − 2 × 60 = 360 mm. Three devices 100 mm wide each take up 300 mm; 60 mm remains for gaps and other requirements. These are chosen teaching inputs, not dimensions of the ED or ES mounting plate.
If the instructions for each model device require larger total clearances, the layout will not fit even with a positive remainder. The calculation checks a single section through the assembly. It does not prove the load capacity of the plate, the space in front of the terminals, screwdriver access or the temperature inside the enclosure.
Mounting and diagnostics after fitting
During mounting, follow the instructions for the exact version, especially for handling, anchors and connecting parts. Check the geometry of the frame before final tightening. Heavy devices need documented fixing; their load cannot be estimated just from the plate thickness. Electrical fitting and protective bonding of accessible metal parts must be designed and verified by a qualified person.
If the doors start to rub after installation, compare the state before and after anchoring. Check the floor, frame position, hinges and collisions with the wiring. Tightening the lock harder may hide the cause and stress the seal unevenly. In the event of overheating, record the load and the location of heat generation; the next steps are described in Cooling, heating and lighting of control cabinets.
FAQ
Can ED and ES be interchanged according to their outer dimensions?
Not without checking the drawings and accessories. The mounting interfaces, usable space and the requirements of the specific assembly are decisive.
Is the number of devices enough for the selection?
No. Include the cable routes, weight of the equipment, waste heat and service access. Devices of the same width may require different depth and clearances.
An overall overview is offered by Control cabinet enclosures. For a different environment, also compare Stainless steel and circuit-breaker enclosures.