Plastic Limit Switches IP65
Select a plastic limit switch according to the mechanical movement that is to actuate it and according to the function of its contacts. The housing is only one part of the assembly: the roller, plunger or lever may be made of a different material. The rigidity of the mounting is also important. If the bracket bends during approach, the actual switching position relative to the machine changes, even if the switch itself is set correctly.
The L5 series and specific actuator variants
The range includes, for example, EMAS L5K13MEM123 with an adjustable roller, L5K13MUM331 with direct actuation via a wheel and spring versions L5K13SOP101 or L5K13SOP102. In addition to snap-action variants, slow-action versions are also represented. Before selecting, therefore, separate the head shape from the function of the contact block.
For L5K13MEM123 the manufacturer states a metal roller of 18 mm, contacts 1NO + 1NC with snap action and protection IP65. The housing has one cable entry with a choice of the matching cable gland; the specific version must be distinguished. Documentation is provided by EMAS for L5K13MEM123. Matching housing size alone is therefore not sufficient for replacement.
The cam must actuate the switch, not stop the drive
The ramp surface should create a smooth and repeatable movement in the permitted direction. With a wheel, it is important that it can roll and is not stressed by lateral sliding. With a direct plunger, check the force guidance according to the drawing. Check the departure of the cam separately: the actuator must return and reach the required initial state again before the next cycle.
Overtravel refers to the further movement of the actuator from the switching position to the total travel position; this term is defined in the OMRON glossary. It is not free space that can be hit without limits. For a specific product, its permitted operating range and mounting recommendations must be respected.
Model example: the usable travel window
Consider a model linear actuator that needs to reach at least 2.8 mm, but must not exceed 4.5 mm in the given design. The cam is set to 4.0 mm and the sum of geometric tolerances is ±0.3 mm. The actual travel achieved therefore lies between 3.7 and 4.3 mm. The reserve relative to the required minimum is 0.9 mm and relative to the upper limit only 0.2 mm.
All values are the author's own and do not describe the travel of the listed L5. The example shows that reliably reaching the switching point does not yet mean a sufficient reserve against overtravel. With a rotary lever, a similar check would be carried out with its angles and transmission geometry, not by taking over these millimetres.
Protection, maintenance and FAQ
To maintain the declared degree of protection, the cable, cable gland, seal and housing closure must all be suitable. A plastic cover is no reason to assume resistance to any oil or cleaning agent. Assess chemical exposure and temperature separately. If you need a different housing, compare Metal Limit Switches IP65; for service work, see Limit Switch Spare Parts.
Is a plastic housing proof of electrical insulation of the whole machine?
No. Electrical protection and permissible use are based on the documentation of the entire installation, not only on the material of the outer cover.
Does a snap-action contact eliminate signal bounce?
No. The way a contact switches does not automatically mean a perfectly clean pulse at the control input. Any filtering must be matched to the shortest valid actuation.