Control cabinet enclosures
A control cabinet enclosure forms the mechanical basis for installing control and electrical devices. The selection does not start with the outer dimensions alone: you need to know the environment, the list of components, how the cables are brought in and the expected service interventions. An empty enclosure is not a finished control cabinet. The properties of the resulting assembly must be assessed after fitting the devices and making the mounting holes.
Guide by design and use
The outer dimension is not the usable mounting area
Draw the components in the drawing, including terminals, connectors and the space needed for removal. Separately allow for cable trunking, a reserve for bending conductors and the wiring to door-mounted devices. Check the depth of the assembly from the mounting surface to the closed door; the available space cannot be derived directly from the outer depth of the enclosure without a design drawing.
The manufacturer card Rittal AX 1045000 states the dimensions of the enclosure and the mounting plate separately. This is an useful model for comparing offers: require both figures, not just one number from the commercial name. An exact numerical comparison of this model can be found in the guide to sheet steel enclosures.
Environment, entries and service access
Divide the description of the installation site into temperature, humidity, dust, exposure to liquids, chemicals and mechanical stress. Do not reduce these influences to a single general requirement “outdoor version”. Also prepare the fixing method and accessibility once the machine is finished. The doors must be able to open in the real space, not just on the floor plan of an empty hall.
Supplement the cable list with their outer diameters and directions of approach. Only on this basis are glands, fittings and the required entry area selected. An extra hole is not a mounting reserve if it remains unsealed. The design of the entries and the seals used must meet the requirements of the enclosure and accessory manufacturers.
Author's example of a layout check
On a model mounting surface 400 mm wide, consider devices with a total width of 250 mm and two trunkings of 40 mm each. 70 mm remains for other needs. This result is not automatically a sufficient reserve: it does not yet address the prescribed clearances, terminals, wiring between rows or depth. The dimensions are chosen only to illustrate the procedure; they are not parameters of the enclosure offered.
Thermal design is a separate task
Record the power losses of the components and their permitted ambient conditions. Assess the layout of the assembly and the thermal design together, especially for power supplies, power switches and drives. The number of fitted devices is not enough for selecting accessories. The documentation should capture the actual load, operating mode and the highest expected temperature at the installation site.
FAQ
Does the same protection rating mean two interchangeable enclosures?
No. Also compare the material, mechanical layout, mounting options and specific conditions of use. The protection rating alone does not describe these properties.
Can I order just by the dimensions of the original enclosure?
For a replacement, also attach a drawing of the fitting, entries and fixing. Verify the scope of delivery of the plate, lock and other parts. The design and verification of the electrical assembly belong to a qualified person.