Ceramic infrared emitters
Choose a ceramic infrared emitter according to the task the heating field is to perform. Uniform preheating of a board is assessed differently from short exposure of a moving web. Before buying, define the permissible temperature non-uniformity, cycle time and the method of inspecting the finished product. The sum of watts alone does not describe these requirements.
How energy gets into the material
Infrared radiation transfers energy without direct contact of the heating element with the product. According to the ELSTEIN explanation of emission and absorption the incident radiation is partly absorbed, reflected or transmitted depending on the material and wavelength. The absorbed part is decisive for heating. The electrical power input is therefore not the same as the power actually received by the product.
In the brief, separate three values: the emitter temperature, the product surface temperature and the required temperature inside the product. During testing, determine which value decides the result of the process. If acceptance evaluates the whole cross-section, it is not enough to record only the hottest spot on the surface. The chosen measurement must correspond to this objective.
Choosing the branch and field layout
For a specific version, continue to the categories Energy-saving ceramic infrared emitters Elstein - HTS and Economical ceramic infrared emitters Elstein - FSR. The branch High-speed infrared emitters currently contains no product items.
ELSTEIN design principles recommend verifying the required power and exposure time by testing the material. When designing the heating assembly, they require thermal expansion and protection against contact with hot parts to be taken into account.
For your own design, draw the outline of the product, the movement, shading by the fixture and the measuring points. Divide the acceptance report into centre, edges and corners. Define a separate permissible interval for each point. This makes it possible to distinguish an insufficient total energy input from unsuitable spatial distribution without reducing the selection to a single highest measured temperature. Also record the initial temperature of the part, its orientation and loading method. Restore these conditions when repeating the test. A change in the result will then not unnoticedly mix the influence of the machine setting with different sample preparation.
Author's model example: balance before testing
Consider a purely model part with a mass of 0.20 kg, a constant specific heat capacity of 1.5 kJ/(kg·K) and a required temperature increase of 80 K. The ideal energy is Q = m·c·ΔT = 24 kJ. If it is to be delivered in 30 seconds, the average power received by the part is 0.80 kW. The model neglects heat losses, evaporation and phase change; it does not determine the power input or a specific emitter.
If, purely for the sensitivity of the calculation, we choose a share of energy received by the part of 0.40, the required electrical input of the model will be 2.0 kW. This share is a fictitious input, not an ELSTEIN efficiency. In the project, it must be replaced by measurement. The example shows why the electrical and material balances are kept separate.
Mounting and diagnostics of the assembly
The ELSTEIN mounting instructions entrust installation to electrically and thermally qualified personnel. They require suitable equipment, protection against contact and a non-combustible support structure. Damaged emitters must not continue to be operated.
When looking for the cause of non-uniformity, always compare the same place on the product and the same moment of the cycle. Record changes to the fixture, recipe and input material. If the deviation repeats only in one position, prepare a test focused on that position. Leave electrical checks and interventions to a qualified worker after the equipment has been safely shut down.
FAQ
Does a high emitter temperature prove correct heating of the product?
No. Define acceptance conditions for the product and verify them separately. The emitter value may serve to control the source, but it does not replace checking the process result.
Is it enough to keep the original recipe when changing material?
It is a starting point for a new test, not a confirmed production procedure. Compare the results on the actual material, including the edges, repeatability and quality after completion of the cycle.