Insulated crimp cable ferrules
An insulated crimp ferrule gathers the strands of a conductor into a termination designed for a compatible terminal. Its plastic collar helps guide the insulated part of the conductor, but does not replace the insulation of the whole terminal. This category is used for selecting the version and size before preparing the individual joints. First determine which conductor and which terminal are to be connected; the colour or approximate appearance of the ferrule is only auxiliary information.
Single ferrule, twin ferrule and butt connector
For one conductor, continue to single insulated ferrules. For the joint termination of two conductors, use twin insulated ferrules, provided the version is also acceptable for the connection point. A twin ferrule by itself does not permit two conductors in the terminal and does not replace the conditions of the device manufacturer.
The range includes single ONKA items from a size of 0.5 mm² and twin variants designated with two cross-sections. A separate type here is the heat-shrink crimp butt connector BHT1 for joining conductor ends. A butt connector does not create the same contact end as a ferrule. For connection under a screw with a ring, choose instead insulated cable lugs.
How to read the size designation
In a designation such as 1.5 × 8, the first value represents the conductor cross-section in mm² and the second usually the length of the metal sleeve in millimetres; always verify the meaning in the description of the given item. For the twin version, the notation 2 × 1.5 expresses two conductors of the relevant cross-section. It is not an automatic recommendation for a terminal marked with a different total value.
Colour systems differ. The Phoenix Contact ferrule overview distinguishes several colour series, so it is not possible to create one universal colour-to-cross-section conversion for all products. In production documentation it is more reliable to state the numerical size, length and order code. The colour can be added for orientation when preparing material.
Procedure for repeatable production
Divide the bill of materials by ferrule type, cross-section, length and pack. Before starting a series, verify the size of the termination in the receiving terminal and the suitable crimping tool. Weidmüller documentation on termination quality points out the importance of the correct combination of components and tool. The mere presence of a ferrule is therefore no proof of a quality joint.
The workplace should have clearly separated containers and a documented procedure setting. After a change of supply or tool, verify the first piece again. The inspection should catch missing strands, damaged insulation and an unsuitable conductor position, not just a visually regular jaw imprint. Determine tests and their frequency according to your own production process and the equipment requirements.
Model example: count terminations, not just conductors
Our own brief contains 70 joints with a single ferrule and 12 joints with a twin ferrule. The requirement is 82 terminals, but 94 conductor ends are processed: seventy separate and twenty-four terminated together. Both numbers matter in the production plan and are not interchangeable.
Only after dividing these joints by cross-section and length can the packs be calculated. Unused twin ferrules cannot automatically be moved to single joints just because the purchase quantity would then work out. Choose other related parts in the overview of electrical consumables.
FAQ
Must every stranded conductor have a ferrule?
It depends on the design and documentation of the terminal. Some connection systems allow different methods of conductor preparation; the correct variant cannot be determined by habit from other equipment.
Is a longer ferrule more universal?
No. The contact length must match the receiving point and the prescribed conductor preparation. Excess length may impair the connection geometry.