Prices include the recycling fee.
Through-beam laser barriers: emitter and receiver
Direct optical path
A through-beam barrier uses a separate emitter and receiver on opposite sides of the monitored space. The object changes the received light by interrupting the beam. No reflector is needed, but the electrical and mechanical connection must be prepared on both sides. A narrow beam can help monitor small objects; the detection capability is also determined by the geometry of the object and the properties of the specific model.
Selection data: through-beam laser barriers (receiver + emitter)
| Step |
What to document |
| Identification |
full designations of emitter and receiver |
| Operating requirements |
beam path and object size |
| Acceptance |
axis, detection interval and control response |
Verification of the whole pair
The listing includes LANBAO PSE-TM30 pairs and TECHNOLINE assemblies TLS0001 or TLS0002. Confirm the exact designations of the emitter and receiver and whether both are included in the delivery. Distinguish the emitter supply from the receiver output. An identical housing or similar connector does not prove a compatible pair; for a replacement, record both original designations.
Adjustment and mechanical stability
During mounting, assess the optical axis in the worst permitted position of the frame. A long distance can magnify the effect of a small angular shift. Access for adjustment and sufficiently rigid brackets are therefore just as important as space for the housings themselves. After final tightening, repeat the test and check that cables or covers do not intrude into the beam.
Angular deviation model
A purely geometric example: at a distance of 5 m and an axis deviation of 0.1° the lateral offset 5 × tan(0.1°) is approximately 8.7 mm. This is not the permitted deviation of any series or data on the beam diameter. The example explains why a seemingly small change in the bracket can show up at the opposite receiver.
Signal acceptance and application
Verify the clear path, interruption by the actual object, the smallest monitored part and the operating speed. Record the selected output logic, supply, PNP/NPN and the response of the downstream input. Confirm the laser class and instructions for its use according to the documentation. A standard laser process barrier is not automatically a safety light curtain intended for personnel protection.
FAQ
Can the receiver and emitter be purchased independently?
Only if they are precisely identified and the manufacturer confirms their joint function. Also check the scope of the specific delivery.
Is it enough to increase the sensitivity in case of a fault?
First check the axis, brackets, contamination, supply and the actual state of the beam.
Related selection: Diffuse laser sensors (reflection from material) · Retro-reflective laser sensors (with reflector).
Documents for further verification: manufacturer's documentation.