CHANA residual current devices
Choose a residual current device according to the protective concept of the installation and the connected equipment. The CHANA range includes versions designated EKL1-63 for single-phase and three-phase arrangements. The number of poles, rated current and the figure in milliamps describe different properties. Before ordering, the full code, the actual protective function and the corresponding documentation of the specific product must be verified.
First distinguish between RCCB and RCBO
An RCCB on its own has no overcurrent protection; a combined RCBO contains it. Documentation of one function does not automatically confirm the other. The current ETEK manufacturer card EKL1-63 classifies the described version as an RCCB. For the variant offered, always require confirmation of the full designation and the corresponding data sheet, not just a match of the family name. The downstream protection must be based on this verified function.
What amps and milliamps mean
In denotes the rated current of the device. IΔn is the rated residual operating current. These values are not added together and one does not replace the other. For a standalone RCD, do not regard the In value as proof that the device itself will provide overcurrent disconnection when it is exceeded.
Author's example of reading the rating plate: the model designation 16 A and 30 mA contains two different quantities; 30 mA converts to 0.03 A. The calculation is only a unit conversion. It does not say that the RCD limits the consumption of the load to 0.03 A, nor does it represent a guaranteed limit of safe contact. The actual use must correspond to the protection design.
Type AC refers to the residual current waveform
Type AC is intended for sinusoidal alternating residual current. Type A also covers pulsating DC residual currents. The differences are explained in the Schneider Electric overview of RCD types. The AC designation is therefore not universal confirmation of suitability for every device connected to the AC mains.
For electronic loads, drives and other loads, verify the required type according to their documentation and the design. Changing the type just on the basis of price or the same sensitivity may overlook an essential property of the protection. At the same time, do not assume that a single letter describes all conditions of use.
Documentation for wiring and commissioning
Prepare the circuit diagram, required pole arrangement, voltage, load and downstream protective elements. Verify the connection conditions, including the function of the marked terminals and the test circuit. The specific wiring must not be derived from a photo of a similar device. Mounting, measurement and evaluation of the protection belong to a qualified person.
The test button is not a complete test of the installation
The TEST button checks the internal tripping function under the manufacturer's conditions; by itself it does not provide a measured tripping time or complete verification of the installation. This difference is pointed out by the ICS Schneider Messtechnik technical overview. Take the interval and procedure of the user test from the instructions of the specific device.
For servicing, record the circuit identification, the state of the connected equipment and the circumstances of the trip. An accurate record helps separate a change in operating conditions from a fault. Do not solve repeated tripping by bypassing the RCD or changing the sensitivity without professional assessment.
FAQ
Is the same 30 mA enough for a replacement?
No. The sensitivity type, current size, poles, voltage, protective function and other assembly conditions must also match.
Does the TEST button confirm overcurrent protection?
No. The presence of an overcurrent function is verified separately from the designation and documentation. Related products can be found in the CHANA protection category.