UZAM 70P8131/S14C, BAUMER, ultrasonic sensor with two switching points, 600–6000mm, PNP, normally open (NO) / break function (NC), connector M12, IP67

UZAM 70P8131/S14C, BAUMER, ultrasonic sensor with two switching points, 600–6000mm, PNP, normally open (NO) / break function (NC), connector M12, IP67

UZAM 70P8131/S14C is a Baumer ultrasonic sensor with two adjustable switch points for monitoring two distance limits. Working range 600–6000mm. Output PNP, normally open (NO) / break function (NC) and connection connector M12.

Technical parameters – overview

Function and suitable use

Two switching limits are practical, for example, when monitoring the lower and upper limit of an object position or monitoring two levels within the sensor range. The exact meaning of the outputs must be set according to the specific variant.

• The advantage of this variant is a range intended for more distant targets; for stable detection, the working limits of the range must be observed.

How to choose the right variant

• Range: 600–6000mm; design the target position within the declared interval, not on the basis of the series designation.
• Output: PNP, normally open (NO) / break function (NC); check compatibility with the control unit input.
• Mounting: cylindrical version; observe the dimensions and recommended fixing.
• Wiring: The M12 connector is suitable for detachable machine wiring; verify the coding and number of contacts corresponding to this sensor.
• Environment: protection IP67; verify suitability for specific contamination, temperatures or chemical influences according to the operating conditions.

Most frequent selection questions

What are two switch points for?

They allow two set distance limits to be evaluated according to the configuration of the given model.

What connection is needed?

For this model, the stated connection is connector M12. The mating part and pinout must be verified according to the manufacturer's version.

What output does this variant have?

The output circuit is PNP, normally open (NO) / break function (NC). Before connecting, compare it with the input type of the PLC or other control unit.