UZAM 50P6121, BAUMER, ultrasonic sensor with two switching points, 350–2500mm, PNP, normally open (NO), cable 2m, IP67

UZAM 50P6121, BAUMER, ultrasonic sensor with two switching points, 350–2500mm, PNP, normally open (NO), cable 2m, IP67

UZAM 50P6121 is a Baumer ultrasonic sensor with two adjustable switch points for monitoring two distance limits. Working range 350–2500mm. Output PNP, normally open (NO) and connection cable 2m.

Technical parameters – overview

Function and suitable use

Two switching limits are practical, for example, when monitoring the lower and upper limit of an object position or monitoring two levels within the sensor range. The exact meaning of the outputs must be set according to the specific variant.

• The advantage of this variant is a range intended for more distant targets; for stable detection, the working limits of the range must be observed.

How to choose the right variant

• Range: 350–2500mm; design the target position within the declared interval, not on the basis of the series designation.
• Output: PNP, normally open (NO); check compatibility with the control unit input.
• Mounting: cylindrical version; observe the dimensions and recommended fixing.
• Wiring: The cable version allows direct routing to the switchboard. During mounting, verify the cable length, strain relief and suitable cable protection.
• Environment: protection IP67; verify suitability for specific contamination, temperatures or chemical influences according to the operating conditions.

Difference from a related model

Compared with the variant UZAM 50P6121/S14 this model differs in the parameter connection: zde cable 2m, for variant UZAM 50P6121/S14 connector M12. This is decisive when choosing the correct version.

Most frequent selection questions

What are two switch points for?

They allow two set distance limits to be evaluated according to the configuration of the given model.

Jde o cableovou variantu?

Yes. The connection of this model is cable 2m. When designing the cable route, take into account the length and mechanical protection of the line.

What output does this variant have?

The output circuit is PNP, normally open (NO). Before connecting, compare it with the input type of the PLC or other control unit.