UF200.EA0-GP2J.72CV, BAUMER, ultrasonic through-beam receiver, 0–1000mm, push-pull, cable 2m, 4 wires, IO-Link, IP67

UF200.EA0-GP2J.72CV, BAUMER, ultrasonic through-beam receiver, 0–1000mm, push-pull, cable 2m, 4 wires, IO-Link, IP67

UF200.EA0-GP2J.72CV is the receiving part of a Baumer ultrasonic through-beam barrier intended to evaluate the signal of the opposite emitter. Range between the parts of the system: 0–1000mm. Output push-pull; connection cable 2m, 4 wires.

Technical parameters – overview

Function and suitable use

The receiving unit is used in a pair with a compatible ultrasonic through-beam emitter, for example to detect beam interruption by a conveyed object or sheet material. The receiver output must be matched to the control system input.

• The declared setting and communication options can be used via IO-Link; when choosing, verify a compatible IO-Link master and connector wiring.

How to choose the right variant

• Range: 0–1000mm; design the target position within the declared interval, not on the basis of the series designation.
• Output: push-pull; check compatibility with the control unit input.
• Mounting: rectangular version; observe the dimensions and recommended fixing.
• Wiring: The cable version allows direct routing to the switchboard. During mounting, verify the cable length, strain relief and suitable cable protection.
• Environment: protection IP67; verify suitability for specific contamination, temperatures or chemical influences according to the operating conditions.

Difference from a related model

Compared with the variant UF200.EA0-GP2J.72N this model differs in the parameter connection: zde cable 2m, 4 wires, u varianty UF200.EA0-GP2J.72N connector M8, 4 pins. This is decisive when choosing the correct version.

Most frequent selection questions

Is the emitter included in the delivery?

This order code designates the receiving part. The emitter must be selected as a compatible counterpart unless it is listed separately in the order.

Jde o cableovou variantu?

Yes. The connection of this model is cable 2m, 4 wires. When designing the cable route, take into account the length and mechanical protection of the line.

What output does this variant have?

The output circuit is push-pull. Before connecting, compare it with the input type of the PLC or other control unit.