U500.RA0-GP1B.72CU, BAUMER, ultrasonic retro-reflective sensor, 0–1000mm, push-pull, PUR cable 2m, 4×0.25,, IP67

U500.RA0-GP1B.72CU, BAUMER, ultrasonic retro-reflective sensor, 0–1000mm, push-pull, PUR cable 2m, 4×0.25,, IP67

U500.RA0-GP1B.72CU is a Baumer retro-reflective ultrasonic sensor. Detection is set relative to a fixed reference surface, so a change in the monitored space can be detected. Position of the reference surface: 200–1000mm. Declared detection range: 0–1000mm. Connection: PUR cable 2m, 4×0.25,.

Technical parameters – overview

Function and suitable use

The retro-reflective version is chosen when a stable reference surface can be defined in the machine and its covering or a change in distance can be detected. The position and stability of the reflecting surface are essential for correct setting.

How to choose the right variant

• Range: 0–1000mm; design the target position within the declared interval, not on the basis of the series designation.
• Output: push-pull; check compatibility with the control unit input.
• Mounting: rectangular version; observe the dimensions and recommended fixing.
• Wiring: The cable version allows direct routing to the switchboard. During mounting, verify the cable length, strain relief and suitable cable protection.
• Environment: protection IP67; verify suitability for specific contamination, temperatures or chemical influences according to the operating conditions.

Difference from a related model

Compared with the variant U500.RA0-GP1B.72O this model differs in the parameter connection: zde PUR cable 2m, 4×0.25,, u varianty U500.RA0-GP1B.72O connector M12. This is decisive when choosing the correct version.

Most frequent selection questions

Does a retro-reflective sensor need a reference surface?

Yes. The principle of this version is based on a set reference surface; the declared range of its position must be respected.

Jde o cableovou variantu?

Yes. The connection of this model is PUR cable 2m, 4×0.25,. When designing the cable route, take into account the length and mechanical protection of the line.

What output does this variant have?

The output circuit is push-pull. Before connecting, compare it with the input type of the PLC or other control unit.