DB080403-1-03N, LANBAO, sensor distribution box M8, 4 ports 3pin, PVC 3m, NPN

DB080403-1-03N is a sensor distribution box with 4 ports M8 in the 3-pin version. A single fixed PVC cable 3 m long runs to the control cabinet – brown (+), blue (−) and four signal wires – green for port 1, white for port 2, grey for port 3 and yellow for port 4. The box is in the NPN version with NO output. The yellow LED at each socket shows the channel status without you having to go to the PLC.

When to choose this variant

• PVC jacket for static installation. The cheaper choice wherever the cable lies fixed in a duct and does not bend.
• Cable 3 m for a box placed close to the control cabinet – no excess that would have to be folded into the duct.
• NPN version for machines with negative logic – typically Asian production lines and retrofits of older equipment.
• Four ports in 90 mm of length. Fits even where there is no room for an eight-port box.
• Degree of protection IP67. Potted interior, gold-plated contacts and an FKM O-ring – withstands dust, washdown and coolant emulsion. The condition is that every port is either occupied or closed with a cap.
• Current rating 2 A per port, 8 A in total. Enough even for fitting all ports with inductive sensors with higher consumption.

Technical specifications

Parameters according to the Lanbao manufacturer's catalogue (Industrial connection system). The material and length of the feed cable can be customised on request.

Feed cable wire assignment

The 3 m PVC feed cable has 6 cores. The colours correspond to the individual ports as follows:

In the NPN version, the LED is connected to supply plus. Port numbering corresponds to the print on the box cover.

What needs to be ordered additionally

The box is supplied without cables to the sensors. For full occupation, order 4 cables with M8 connector / 3 pins, male. To connect to the sockets of the distribution box, use the following Lanbao male cables and connectors:

The suffix -U denotes a PUR jacket, without it the cable is PVC; F is the straight and G the angled version. Close unused ports with a suitable cap to maintain the box's degree of protection.

Frequently asked questions

How is the box mounted?

With two through-holes in the base. You will find the spacing and diameter of the holes in the parameter table above; the dimension drawing can be downloaded as a PDF.

What is the degree of protection of this distribution box?

IP67. This means complete protection against dust and temporary immersion in water to a depth of one metre. This applies to the box with occupied or capped ports.

Can I connect PNP and NPN sensors to one box?

No. The box is made separately in PNP and NPN variants, and the logic must be the same for the sensors, the box and the PLC input card.