TSUMI0001, TECHNOLINE, miniature inductive sensor, M5, flush, 10–30 V DC, PNP, NO, Sn 1.5 mm, connector M8/3 pins

TSUMI0001, TECHNOLINE, miniature inductive sensor, M5, flush, 10–30 V DC, PNP, NO, Sn 1.5 mm, connector M8/3 pins

TSUMI0001 is a miniature inductive sensor made by TECHNOLINE. According to the source data, the design is characterised by the parameters M5, Sn 1.5 mm, PNP, NO, 10–30 V DC, connector M8/3 pins.

When choosing an industrial sensor, it is advisable to compare the exact order code and all parameters that affect mechanical and electrical compatibility.

Typical applications

Inductive sensors are used for non-contact detection of metal objects, checking the presence of a part, sensing the position of a mechanism, end positions, counting metal components or passing a status signal to the control system. The specific use must match the electrical and mechanical parameters of the given type.

Technical specifications

How to choose the right variant

Before ordering, compare in particular the size and design of the housing, the sensing distance, flush or non-flush face, the output type, contact function, supply and connection method. If you are replacing an existing sensor, start primarily from the exact order code and the parameters of the original device.

Related information and categories

FAQ

What type of sensor is TSUMI0001?
According to the source data, this is a miniature inductive sensor made by TECHNOLINE. The exact version is given in the technical parameters table.

How to choose the right replacement for TSUMI0001?
Compare the order code, mechanical design, sensing distance, output type, NO/NC function, supply and connection method.

What is an inductive sensor used for?
For non-contact detection of metal objects, checking the position or presence of a part and passing a signal to the automation system.

Can the sensor be connected to a PLC?
Yes, if the electrical parameters of the output, the supply and the PLC input match the data of the specific model. These values must be compared before wiring.

What is the difference between PNP and NPN versions?
They differ in the way the output switches. When replacing a sensor, the output type required by the wiring and the control system input must be kept.

What do NO and NC mean?
NO is the normally open function and NC the normally closed function. When replacing a sensor, the function must match the original wiring and the machine logic.

What should be checked before ordering?
The exact code, housing size, sensing distance, flush or non-flush design, electrical output, contact, supply, connector or cable, and environmental conditions.

Where can I find more inductive sensors and selection information?
More variants are in the category inductive sensors. For the working principle and practical selection, you can also use the tutorial on inductive sensors.